Segway SE-3 Patroller User Manual download pdf (Page 55)

Info SE-3 Setup Operate Riding

Tips

Battery Maintain T-shoot Warn Contact

Index Schedule

Partial Charge

Whenever you do not fully charge the SE-3’s Battery Module, partial charge may affect the accuracy of the Battery Module charge level display,

causing it to show a higher charge level than actually exists. After you power on, check the Battery Module charge level display and then operate

the SE-3 Patroller for some time. Check the Battery Module charge level display again. If the Battery Module charge level display shows rapid

charge depletion during this time, the Battery Module has received only a partial charge. If necessary, plug the SE-3 back in and recharge.

Self Discharge

When not in use the Battery Module will continue to discharge at a low rate, slowly draining the Battery Module. Over time this could result in a

low or empty Battery Module. For this reason, Battery Modules should always be plugged in and charging when stored for extended periods of

time.

CAUTION

If left uncharged, an empty Battery Module could become permanently damaged. Always charge Battery Modules when not in use and always

immediately charge a Battery Module that has been depleted.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 91 92

No comments

Segway SE-3 Patroller User Manual Page 55